AprintaPro PrintaFix printbed adhesive spray 250ml - AprintaPro

PrintaFix - the best solution for adhesion problems in 3D printing, no warping anymore.

• easy to use –simple as Shake | Spray | Print!
• cost-effective
• for non-heated and heated printbeds
• removable with warm water

Environmentally friendly

PrintaFix Basic is developed particularly for FDM/FFF 3D printing and is characterized by its ease of use, the low price per print (approx.. 11 cent per print) and excellent adhesion on non-heated and heated printbeds.

With PrintaFix you solve problems with the adhesion far better and more convenient that with other products.

Instruction:

shake -spray - print

Take the printbed out of your 3D printer, shake PrintaFix well, apply overlapping circles on the printbed and start the print as usal. Warping and first layer problems is a thing of the past.
Clean up is done in seconds. Just use warm water or an alcoholic window cleaner (must contain ethanol).

More information:

Recommended settings:

PLA: printing temperature 200-215°C

ABS: printing temperature 235-250°C printbed temperature 80-100°C

5mm brim is recommended

You will get a smooth nice finish on the bottom.

Multiple prints on one PrintaFix coating are possible (Adhesion drops about 20% per print depending on the size of the previous model.)

For extreme high adhesion:

Spray PrintaFix as usual in overlapping circles on the printbed. Wait until it is dried. Then spray again a fine nebula with a few pumps from a distance of 30 cm on the printbed.