AprintaPro PrintaStick - AprintaPro - 50ml

PrintaStick; for perfect adhesion of 3D prints.

PrintaStick works with all materials and ensures perfect adhesion to the print bed until the print is complete. The sponge on the PrintaStick makes the use very simple and precise. During application and printing no unpleasant odors are released from the adhesive. PrintaStick also leaves no trace on the printed object and can be used on heated and unheated printbeds.

Characteristics:

• Special formula that works with many materials
• Very precise to apply
• Stable at high temperatures
• No unpleasant odors
• Removable with water

PrintaStick instruction:

Shake the PrintaStick a few seconds for a good mix of the adhesive. Apply only on a cool and clean print bed. If necessary, you can use PrintaClean to clean the print bed.

Apply the PrintaStick adhesive with the sponge on the print bed. Spread the liquid with a spinning motion with the sponge. If the sponge dries out you can easily clean it with water to make it soft again.

Start the printing process with the recommended print temperature. The applied liquid will dry up during the pre-heating of the print bed, leaving behind a film layer that ensures adhesion with the print object. When the print is complete, rinse with water.

Download PrintaStick Material Safety Datasheet

PrintaStick of PrintaFix   

*With non-heated printbeds, drying will take longer and therefore it may be better to use PrintaFix.